Quantum PX506 Manual de instalación descargar pdf (Pagina 36)

Quantum PX506 and PX510 Unpacking and Installation Instructions

Document 81-81338-01 D01

June 2005

36 Installing Additional Libraries

• Installing the Libraries

• Configuring the Libraries in a Multiple Stack

Removing the FlexLink

Covers

The FlexLink covers must be removed prior to library installation so tape

cartridges can pass between library chassis.

To remove the FlexLink covers:

1 The library modules have pass-through cover plates located on the top

and bottom of the chassis. Depending on the location of the library in the

stack, one or both of the cover plates are removed from the chassis (see

figure 31

Figure 31 Identifying the

Cover Plates for Removal

2 After you have identified the cover plates to remove, use a #2 PHILLIPS

screwdriver to remove the two screws that secure the cover plate to the

library chassis (see figure 32

Note: The cover plate location is the same on both the PX506 and

PX510 libraries.

Library 1

Library 2

Library 3

Library 4

Top library in stack - remove ONLY the

bottom cover plate

Middle library in stack - remove BOTH the

top and bottom cover plate

Middle library in stack - remove BOTH the

top and bottom cover plate

Bottom library in stack - remove ONLY the

top cover plate

1 2 ... 31 32 33 34 35 36 37 38 39 40

Sin comentarios

Quantum PX506 Manual de instalación Pagina 36