Quantum TC2201E Guía de usuario descargar pdf (Pagina 41)

Chapter 2 Getting Started

Interfaces and Connections

Quantum TC2201E User’s Guide 21

end being attached to the TC2201E. The type of connector at the other end

of the cable will be dependent on the device being connected.

Warning: Please be advised that failure to comply with the

minimum high density cable specifications can result in

damage to the TC2201E or an operational failure of the

product.

To connect the TC2201E to a SCSI bus:

1 Power off the SCSI devices on this bus.

2 Connect a SCSI cable to one of the SCSI connectors on the back panel

of the unit. The TC2201E should always be installed at the end of the

SCSI bus.

3 Make sure that the bus is terminated correctly. By default, the

TC2201E is automatically terminated. However, the device at the

other end of bus must also be terminated.

Figure 17 TC2201E

SCSI connection

SCSI buses

4 Power on the SCSI devices on this bus, but not the TC2201E.

5 After all the SCSI devices on this bus have completed their individual

POST (Power-On Self Test) processes, power on the TC2201E.

Note: SE is not supported by SCSI-2 protocols. While it is possible to

mix SE and LVD devices on the same bus, doing so may result

in substantially decreased performance on the bus.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 201 202

Sin comentarios

Quantum TC2201E Guía de usuario Pagina 41