Quantum PX502 Guía de usuario descargar pdf (Pagina 64)

Chapter 2 Basic Library Operations

Installing Tape Cartridges

Quantum PX500 Series User’s Guide 41

3 Place cartridges (right side up) in the fixed slots and magazines:

a Open the library doors (see “Library Operations” on page 68 to

open the library doors).

b Remove the magazines (see “Library Operations” on page 68 to

release the magazines).

c Load the tape cartridges in the magazines and fixed bins. It is

recommended to start loading tape cartridges in magazine 1, bin

0000 (see

“Library Models” on page 2 for magazine and bin

locations).

d Replace the magazines in the library.

e Close the library doors.

Note: In a PX506 and PX510 library, the bottom doors must be

open to open the top doors.

Note: You have approximately 10 seconds to open the doors and

remove the magazines. If you did not complete the

operation, repeat the steps.

Note: In a PX506 and PX510 library, only the bottom magazines

must be released from the OCP. All other magazines can

be removed without being released.

Warning: Do NOT reach into the library to load tape cartridges

into the fixed bins. Use the

Move page located on the

Operations tab from the remote management pages

(see

chapter 3 on page 85) to move tape cartridges

from the magazines into the fixed bins.

Caution: Placing the cartridges in the bins upside down can

cause damage to the library (see

figure 20 for SDLT

cartridges and figure 21 for LTO cartridges).

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 293 294

Sin comentarios

Quantum PX502 Guía de usuario Pagina 64