Quantum L200 Guía de usuario Pagina 32

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 112
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 31
Chapter 2 Installing the Library
Connecting the Library
16 Quantum|ATL PowerStor L200 Series Library Users Guide
Connecting the Library 2
Complete the following procedure to connect the power cord and
SCSI cables to the library (see figure 9
).
Figure 9 Rear Panel
Cable Connectors
To connect the library:
1 Verify that the librarys power switch is in the off position. It is
not necessary to power down the host.
2 Connect one end of the short SCSI cable supplied with the to
the library controllers SCSI connector closest to the tape drive
(see figure 10
).
Caution: Verify that the library controller is connected to the
same type of SCSI bus as the drive on that bus. For
example, connecting a single-ended SCSI library to a
differential SCSI adapter will cause a host system
malfunction.
Power switch
Power connector
Power supply
SCSI connectors
(library controller)
Serial port
(FSE use only)
Tape drive assembly
Connect to a
SCSI device
(or install
terminator)
Connect
together
Connect to
host
Vista de pagina 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 111 112

Comentarios a estos manuales

Sin comentarios