Quantum Q-EKM Guía de usuario descargar pdf (Pagina 45)

Chapter 5 Q-EKM Server Operation and Configuration

Turning Debug Logging On and Off

Quantum Encryption Key Manager Service and Installation Manual 32

be asked to turn debug logging on and then re-create the problem in

order to generate troubleshooting data.

The current debug state (on or off) is listed on the Q-EKM commands

menu under item number

5 (see Figure 5 on page29).

Turning the log on or off shuts down the Q-EKM server, changes the

KeyManagerConfig.properties file, and then restarts the Q-EKM server.

1 Log on to Q-EKM Commands (see Logging On to Q-EKM

Commands on page 27).

2 At the Enter Command prompt, enter

5 (for Set Q-EKM server debug

logging on or off)

The Q-EKM server process stops.

3 When prompted, press

<Enter>.

The Q-EKM server debug mode change menu displays.

Figure 6 Debug Mode Change

4 At the Enter Command prompt, enter 1 to turn debug logging ON;

2 to turn debug logging OFF, or q to quit.

The command is entered into the system.

5 Press

<Enter>.

The Q-EKM server process starts.

Note:

Remember to turn debug off once you have finished gathering

data

. If you forget to do this and the file becomes too large,

stop the Q-EKM server process, delete the

debug_server file,

and restart the Q-EKM server process. This re-creates the

debug log with no data in it. You can then turn debug on or off

as needed.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 92 93

Sin comentarios

Quantum Q-EKM Guía de usuario Pagina 45