Quantum 1200 Series DAT Autochanger Manual de usuario descargar pdf (Pagina 58)

Chapter 3 Installing Your Tape Drive

Configuring and Installing an Internal Tape Drive with SCSI Interface

SDLT 600 Product Manual 42

5 Confirm that your back-up software and operating system are

compatible with the tape drive. See w

ww.dlttape.com for the most

up-to-date compatibility information.

Configuring and Installing an Internal Tape Drive with SCSI

Interface

This section provides information for configuring and installing a tape

drive with SCSI interface into a system. See Configuring and Installing a

Tabletop Tape Drive with SCSI Interface on page 60 for information on

configuring and installing a tabletop tape drive.

Configuring the SDLT 600 tape drive system with SCSI interface includes

the following tasks:

• Setting the SCSI ID for the tape drive (default = SCSI ID 5)

• Configuring the tape drive to provide TERMPWR

• Setting the configuration jumper (default = wide SCSI enabled).

If you want to change any of the settings, refer to the applicable

subsection; otherwise proceed directly to the tape drive’s installation

procedures in Installing the Internal SCSI Tape Drive

on page 47.

Setting the Internal Tape

Drive SCSI ID

Each device on the SCSI bus must have a unique SCSI ID address

assigned to it. For specific recommendations for assigning SCSI IDs, refer

to your system or SCSI controller documentation.

Set the SCSI ID by using jumpers on a set of pins at the rear of the tape

drive. This section discusses setting the SCSI ID on the internal tape drive

via the jumper block. Table 25

and table 26 show the SCSI ID address and

jumper settings.

Caution: Before you begin, review the safety, ESD, and handling

precautions described at the beginning of this chapter to

avoid personal injury or damage to equipment.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 141 142

Sin comentarios

Quantum 1200 Series DAT Autochanger Manual de usuario Pagina 58