Quantum 1200 Series DAT Autochanger Manual de usuario descargar pdf (Pagina 97)

Chapter 4 Using Your Tape Drive

Troubleshooting

SDLT 600 Product Manual

Table 34 Troubleshooting

Chart

If… Then… You should…

System does not recognize the

SDLT 600 tape drive system.

System may not be configured

to recognize the interface ID.

Configure system to recognize

the SDLT 600 tape drive

system’s ID.

Interface ID may not be unique. Change the interface ID and

reconfigure the system. The new

ID becomes effective at the next

power on or interface bus reset.

Interface adapter parameters

may not be correct.

Check interface adapter

documentation.

Interface signal cable may be

loose.

Ensure interface cable is fully

seated at each connector end.

Interface terminator may be

loose or not present on the bus.

Ensure correct, secure

termination of bus.

Interface bus may not be

terminated correctly.

If the SDLT 600 tape drive

system is last or only device on

bus (except for adapter), be

certain the terminator is

installed on the SDLT 600 tape

drive system.

If the SDLT 600 tape drive

system is not the last or only

device on the bus, check the

cable connections and ensure

that the bus is properly

terminated at each end.

Interface terminator may not be

at end of bus or more than two

terminators may be present.

Ensure that a terminator is

installed at each end of the bus.

One terminator is usually

installed at the host end of the

bus.

Interface bus may be too long. Limit bus length to ANSI

interface standard for the

interface being used.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 141 142

Comentarios a estos manuales

Sin comentarios

Quantum 1200 Series DAT Autochanger Manual de usuario Pagina 97

Comentarios a estos manuales

Relacionado con productos y manuales para Las unidades de cinta Quantum 1200 Series DAT Autochanger