
DLT-S4 Product Manual 80
Chapter 10
10Installing an Internal Fibre
Channel Tape Drive
This chapter describes how to configure and install the DLT-S4 internal
Fibre Channel tape drive.
This chapter includes the following information:
• Equipment Required
• Installation Steps
• Rear Panel Connectors
• Unpacking the Tape Drive
• Securing the Tape Drive in the System
• Connecting the Cables
• Confirming the Installation
• Adding Additional Devices
• Using the Loader/Library Interface Connector
Caution: Before you begin, review the safety, ESD, and handling
precautions described in Chapter 2
to avoid personal
injury or damage to equipment.
Comentarios a estos manuales