Quantum DLT 8000 Manual descargar pdf (Pagina 99)

100

101

Configuring, Installing, and Operating the Tape Drive

Quantum DLT 8000 Tape System 2-45

2.9 Troubleshooting

Use Table 2-15 for troubleshooting tips in the event that your tape system fails its

power-on self test or if it signals a problem via its front panel indicators.

Table 2–15 Troubleshooting Chart

If… Then… You Should…

System does not recognize the

tape system

System may not be configured

to recognize the SCSI ID.

Configure system to recognize

the tape system’s ID

SCSI ID may not be unique Change the SCSI ID and

reconfigure the system. The

new ID becomes effective at

the next power on or SCSI bus

reset.

SCSI adapter parameters may

not be correct

Check SCSI adapter

documentation

SCSI signal cable may be loose Ensure SCSI cable is fully seated

at each connector end

SCSI terminator may be loose

or not present on the bus

Ensure correct, secure

termination of bus.

SCSI bus may not be

terminated correctly

If tape system is last or only

device on bus (except for

adapter), make sure terminator

is installed on tape system.

If tape system is not the last or

only device on the bus, check

the cable connections and

ensure that the bus is properly

terminated at each end.

SCSI terminator may not be at

end of bus or more than two

terminators may be present

Ensure that a terminator is

installed at each end of the

bus. One terminator is usually

installed at the host end of the

bus.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 407 408

Comentarios a estos manuales

Sin comentarios

Quantum DLT 8000 Manual Pagina 99

Comentarios a estos manuales

Relacionado con productos y manuales para Las unidades de cinta Quantum DLT 8000