Quantum LTO-4 (Model B) Información técnica descargar pdf (Pagina 10)

10 Installing the Tabletop LTO-4 (Model B) Half-Height Tape Drive

Product Name Quick Start Guide

1 Configuring the Tabletop Parallel SCSI Tape Drive

2 Connecting the Tabletop Drive Interface and AC Power Cables on page 11

Restarting the Tabletop Tape Drive System on page 14

Installing the LTO Driver Software on page 14, if required

Registering the LTO-4 (Model B) Half-Height Tape Drive on page 15

Configuring the

Tabletop Parallel SCSI

Ta p e D ri v e

The factory-set default configuration of the tabletop parallel SCSI LTO-4 (Model B) Half-

Height Tape Drive is:

• SCSI ID: 6

• Terminator power: enabled

IF the default parallel SCSI ID

con

figuration is . . .

THEN you can . . .

compatible with your system

SI bus,

skip the following subsection and proceed to

Configuring the Internal Parallel SCSI Terminator

Power on page 5.

already assigned to another

device,

change the configuration of either the other

vice, or the LTO-4 (Model B) Half-Height Tape

Drive, as described in the following subsection.

Note: You cannot disable terminator power on a tabletop parallel SCSI drive.

Configuring the Tabletop Drive Parallel SCSI ID

Each device on the parallel SCSI bus must have its own unique SCSI ID. Use the push-

button SCSI ID selector switch on the drive back panel to change the SCSI ID of the

tabletop LTO-4 (Model B) Half-Height Tape Drive (see figure 8

serial-attached SCSI (SAS), there is no need to configure the SCSI ID, as SAS is

a point-to-point architecture. Skip to

Connecting

the Tabletop Drive Interface and AC Power Cables

on page 11.

IF the drive interface is . . . THEN . . .

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Sin comentarios

Quantum LTO-4 (Model B) Información técnica Pagina 10