Quantum LTO-4 (Model B) Información técnica descargar pdf (Pagina 4)

4 Installing the Internal LTO-4 (Model B) Half-Height Tape Drive

Product Name Quick Start Guide

2 Connecting the Internal Drive Interface and DC Power Cables on page 7

Restarting the Internal Tape Drive System on page 9

Installing the LTO Driver Software on page 14, if required

Registering the LTO-4 (Model B) Half-Height Tape Drive on page 15

Configuring the

Internal Parallel SCSI

Ta p e D ri v e

The factory-set default configuration of the internal parallel SCSI LTO-4 (Model B) Half-

Height Tape Drive is:

• SCSI ID: 6

• Terminator power: enabled

IF the default parallel SCSI ID

con

figuration is . . .

THEN you can . . .

compatible with your system

SI bus,

skip the following subsection and proceed to

Configuring the Internal Parallel SCSI Terminator

Power on page 5.

already assigned to another

device,

change the configuration of either the other

vice, or the LTO-4 (Model B) Half-Height Tape

Drive, as described in the following subsection.

Configuring the Internal Drive Parallel SCSI ID

Each device on the parallel SCSI bus must have its own unique SCSI ID. Use SCSI

configuration jumper pins 1–2, 3–4, 5–6, and 7–8 on the drive back panel to change the

SCSI ID of the LTO-4 (Model B) Half-Height Tape Drive (see figure 2

1 2 3 4 5 6 7 8 9 ... 17 18

Sin comentarios

Quantum LTO-4 (Model B) Información técnica Pagina 4