Quantum LTO-4 (Model B) Información técnica descargar pdf (Pagina 3)

Installing the Internal LTO-4 (Model B) Half-Height Tape Drive 3

Product Line

• For a SAS drive, either:

• 29-pin SFF-8482 SAS cable for an internal drive

Note: Power is not integrated with the SAS connector. Power is provided

via a separate 4-pin Molex® connector.

• 26-pin SFF-8088 mini-SAS style interface cable for a tabletop drive

• Backup application software that supports the tape drive. F

or a list of the backup

software applications that have been tested with the LTO-4 (Model B) Half-Height

Tape Drive, please visit our website at:

www.quantum.com/suppor

Unpacking and

Inspecting the Drive

Although each LTO-4 (Model B) Half-Height Tape Drive is inspected and carefully

packaged at the factory, damage can occur in shipment or when the drive is being

unpacked.

Observe the handling precautions in Handling Precautions and Installation Guidelines

and carefully unpack and inspect the LTO-4 (Model B) Half-Height Tape Drive as follows:

1 Visually inspect the shipping container and notify your carrier immediately of any

damage.

2 Place the

shipping container on a flat, clean, stable surface and carefully remove the

contents.

3 Vi

sually inspect the LTO-4 (Model B) Half-Height Tape Drive and notify your

Quantum representative immediately of any damage.

4 Al

ways save the shipping container and packing materials for any future

reshipment.

Installing the Internal LTO-4 (Model B) Half-Height Tape Drive

To install the internal LTO-4 (Model B) Half-Height Tape Drive, complete the following

procedures in the order presented:

1 Depen

ding on the interface configuration of the drive:

IF the drive interface is . . . THEN . . .

parallel Small Computer

System I

nterface (SCSI),

proceed to Configuring the Internal Parallel SCSI

Tap e Dr iv e in the following subsection to configure

the parallel SCSI ID and bus terminator power.

serial-attached SCSI (SAS), there is no need to configure the SCSI ID or bus

terminati

on, as SAS is a point-to-point

architecture. Skip to

Mounting the Internal Tape

Drive on page 6

1 2 3 4 5 6 7 8 ... 17 18

Comentarios a estos manuales

Sin comentarios

Quantum LTO-4 (Model B) Información técnica Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Las unidades de cinta Quantum LTO-4 (Model B)