Quantum LTO-4 (Model B) Información técnica descargar pdf (Pagina 9)

Installing the Tabletop LTO-4 (Model B) Half-Height Tape Drive 9

Product Line

• Attach the internal SCSI interface cable to the 68-pin parallel SCSI connector

on the back of the drive.

Caution: The LTO-4 (Model B) Half-Height Tape Drive with the parallel SCSI

interface is a low voltage differential (LVD) SCSI device. Install it

only in LVD environments. Plugging an LVD drive into a high

voltage differential (HVD) bus makes the entire bus nonfunctional

and may permanently damage the drive or other SCSI devices on

the bus.

• See the internal parallel SCSI bus termination examples in figure 3 on page 6

to check/verify the system SCSI bus configuration and install a 68-pin LVD

SCSI bus terminator, as required.

b For the SAS internal drive, attach the internal SAS interface cable to the 29-pin

SFF-8482 SAS connector on the back of the drive.

3 Connect the internal drive DC power cable to the DC power connector on the back

of the drive.

4 Reinstall the system cover.

5 Reconnect the system AC power cord to the facility AC power receptacle.

After connecting the internal drive interface and DC power cables, proceed to Restarting

the Internal Tape Drive System in the following subsection.

Restarting the Internal

Tape Drive System

After connecting the internal drive interface and DC power cables:

1 Restart the workstation or server system.

2 Verify that the internal LTO-4 (Model B) Half-Height Tape Drive comes on and

completes the Power On Self Test (POST) functions.

3 As required, proceed to either:

• Installing the LTO Driver Software on page 14

• Registering the LTO-4 (Model B) Half-Height Tape Drive on page 15

Installing the Tabletop LTO-4 (Model B) Half-Height Tape Drive

To install the tabletop LTO-4 (Model B) Half-Height Tape Drive, complete the following

procedures in the order presented:

1 Depending on the interface configuration of the drive:

IF the drive interface is . . . THEN . . .

parallel Small Computer

System Interface (SCSI),

proceed to Configuring the Tabletop Parallel SCSI

Tap e Dr iv e in the following subsection to configure

the SCSI ID.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Sin comentarios

Quantum LTO-4 (Model B) Información técnica Pagina 9