Quantum ValueLoader Manual de usuario descargar pdf (Pagina 65)

Diagnostics and Troubleshooting

Troubleshooting

ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual 51

Non-acclimated media. • A cartridge should be acclimated for a minimum of 24 hours

before being used, particularly if it has been stored at a

substantially different temperature or level of humidity than

the ValueLoader.

Wrong cleaning cartridge. • Make sure you are using a Quantum compatible cleaning

cartridge.

Bad/defective/

contaminated media.

• If the Media Attention LED is cleared using a cleaning

cartridge and then immediately reappears each time a

particular cartridge is reloaded, and you have confirmed that

the suspect cartridge is not invalid (DLTtapeIII cartridge or

non-Quantum cleaning cartridge), that cartridge should be

suspected as being contaminated.

• If this occurs, export the cartridge, clean the tape drive again,

and then load a known good cartridge. In some cases, a

cartridge can be worn out, have bad calibration tracks, have

been improperly degaussed, or have a bad tape directory

recorded by another drive type such as DLT7000 or DLT8000.

• Any cartridge that is suspected of being defective or

contaminated should NOT be reused in any drive. Cartridges

that are suspected as being improperly degaussed or

containing incompatible formats such as DLT7000 or DLT8000

must be thoroughly degaussed before use.

Expired cleaning cartridge. • A cleaning cartridge is good for 20 uses.

Errors Displayed on the Front Panel

Problem Solution

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 87 88

Sin comentarios

Quantum ValueLoader Manual de usuario Pagina 65