Quantum ValueLoader Manual de usuario Pagina 67

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 88
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 66
Diagnostics and Troubleshooting
Removing Stuck Cartridges
ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual 53
2 Remove the power cable and SCSI cables from their connectors on the
back panel of the ValueLoader.
3 Remove the ValueLoader from its rack slot, if applicable, and place it
on a table or other clear work surface.
4 Use a screwdriver to remove the front cover screws that secure the
mounting brackets (if the ValueLoader is rackmounted) from both
sides of the ValueLoader, as shown in figure 15
.
Figure 15 Removing
Mounting Brackets
(Left Side Shown)
5 Remove the five screws on the back of the ValueLoader, and two
additional screws, one on each side of the ValueLoader, to loosen the
ValueLoader cover.
6 Remove the top cover by lifting it from the back and easing it out
from under the front panel display cover.
Warning: To prevent injury, disconnect the power and SCSI
cables before removing the ValueLoader cover and
keep fingers away from the fan.
Vista de pagina 66
1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 87 88

Comentarios a estos manuales

Sin comentarios