
6 Getting Started
For the most part, installation of the desk-top unit is simply a matter of checking all necessary
SCSI connections, installing the application software (backup or otherwise) on the host
computer, and applying power. Installtion of the rack-mount unit requires that you first install
the rack rails, a cable channel, and channel stop to your rack before continuing the installation.
Requirements
• Space requirements: your Scalar 218 desk-top unit has a footprint of 19.0" wide by 24.5"
deep by 11.0” high. You must allow adequate clearance to the rear to allow air flow and
enough room at the top to permit you to insert and remove the data cartridges through the
sliding access panel. The rack-mount unit must have adequate clearance above the unit,
when it is pulled out of the rack to the stop limits, to permit you to insert and remove the
data cartridges through the top.
• We assume that you are familiar with your computer system. The Scalar 218 must be
incorporated into the host computer system. The backup software, SCSI interface card
and any additional SCSI cables must be purchased separately.
• Necessary tools: No special tools are required to install the Scalar 218 desktop unit. To
install the rack-mount unit, you will need the following tools:
+ A # 1 Phillips screwdriver.
+ An 11/32 inch hex driver.
Unpacking and Inspecting
Warning
The Scalar 218 weighs 70 pounds when it is equipped with 2 drives. Do
Not attempt to lift the Scalar out of the packing box by yourself. See
adic document 63-1174-01, taped to the outside of the poly bag
surrounding the Scalar, for complete unpacking instructions.
Following the procedures described in Scalar 218 Unpacking Instructions (adic document
63-1174-01), unpack all items from the carton. Save the packing materials in case you need to
move or ship the system in the future.
Caution
You must ship the Scalar 218 in the original or equivalent packing
materials or your warranty may be invalidated.
Comentarios a estos manuales