Quantum Scalar 218 Especificaciones descargar pdf (Pagina 34)

24 Equipment Description

Drive 2Drive 1

Library Robotics

SCSI Configuration 3 — Three SCSI Buses

p Check that the power switches on both your Scalar 218 and your host computer are off.

p Attach one end of the SCSI interface cable(s) to the connector(s) shown on the rear of

your Scalar 218. Press firmly, then tighten the jack screws on the high density (68-pin)

connector(s) and secure the bail locks on any low density (50-pin) connectors.

p Plug the other end of the SCSI interface cable(s) into the external connector(s) on the

SCSI interface card(s). Tighten the jack screws on the high density (68-pin) connector(s)

and secure the bail locks on any low density (50-pin) connectors.

Note

The jack screws and any bail locks at both ends of the SCSI cable(s)

must be securely fastened in order for your library to communicate

properly with the computer.

p Install an external terminator(s) on the appropriate SCSI connector(s) on the rear of your

Scalar 218.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 108 109

Sin comentarios

Quantum Scalar 218 Especificaciones Pagina 34