Quantum Scalar 218 Especificaciones descargar pdf (Pagina 91)

Scalar 218 Rack-Mount Installation 81

Warning

The Scalar 218 weighs 70 pounds when it is equipped with 2 drives. Do

Not attempt to lift the Scalar by yourself. To avoid possible injury, and

damage to the equipment, always use 2 people to lift the Scalar.

p While depressing both slide stop releases, slide the Scalar off the outer slides.

If the holes in the uprights of your rack are square, you must install the plate/rail subassembly

using the collared spacers included in the hardware. This will position the rails correctly.

If the holes in the uprights of your rack are round, it is not necessary to use the collared

spacers when installing the plate/rail subassembly. The hole diameter will cause the mounting

screws to be positioned correctly.

p While a helper holds the plate/rail subassembly in position, secure each rail mounting

flange to the rack upright with a spacer (required if square holes, optional if round holes)

and a 10-32 x ½” Phillips head screw. Be sure that the small end of the spacer is inserted

completely into the hole in the upright. Tighten the screws.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 108 109

Sin comentarios

Quantum Scalar 218 Especificaciones Pagina 91