Quantum Scalar 218 Especificaciones descargar pdf (Pagina 89)

Scalar 218 Rack-Mount Installation 79

p Mount the outer rails to the Scalar 218 by placing each rail over the 3 studs on each side

of the unit. Loosely secure the outer rails to the studs using 3 Nylock nuts. Do not tighten

the nuts completely. The following illustration shows the location of the rail mounting

studs.

p Adjust the position of the outer rails until the distance between the outside surface of the

mounting flanges is equal to the measurement you recorded when you measured the

distance between the rack uprights.

p Once the rail length is adjusted, tighten the Nylock nuts securely.

The next step in the installation process is to remove the Scalar from the rails so that you may

install them in your rack.

For maximum protection, your rack-mount Scalar 218 was shipped from the factory with the

front panel locked in the closed (operating) position. The front panel lock serves two

purposes; when engaged with the key, the Scalar 218 cannot be pulled forward on its slides,

preventing unauthorized access to the data cartridge storage bay; when disengaged, the lock

works as a latch, holding the Scalar 218 in the operating position.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 108 109

Sin comentarios

Quantum Scalar 218 Especificaciones Pagina 89