
Chapter 1 Library Description
Getting Started
Quantum PX720 User’s Guide 39
6 To edit the setup information, use the up and down arrows to
highlight the section and press
Select.
• To set the IP address, subnet mask, and gateway, use the up and
down arrows to select the appropriate number and press
Select
to accept.
• To enable/disable DHCP, use the up and down arrows to toggle
between enable/disable. Press
Select to accept the setting. If your
library is not connected to a network which uses a DHCP server
to assign IP addresses, disable this function.
• To change the password, use the up and down arrows to select
Change Password and press
Select. To change the password,
enter a 6-digit password using the numbers provided on the
OCP. Press
Select to accept the new password. When prompted,
re-enter the password to confirm.
• To enable drive autoclean, use the up and down arrows to select
Drive Autoclean and press
Select.
• To enable drive autounload, use the up and down arrows to
select Drive Autounload and press
Select.
• To enable the left load port, use the up and down arrows to select
Left Load Port (16) and press
Select.
• To enable the right load port, use the up and down arrows to
select Right Load Port (32) and press
Select.
7 When you are finished viewing/editing the setup information, press
Back twice to return to the Home screen.
8 From the Home screen, press Ops to enter the operations screen.
9 Before the network information can become active, the cabinet must
reboot. To reboot the cabinet, use the up and down arrows to
highlight the cabinet and press
Select.
10 Use the up and down arrows to select the reboot option and press
Select.
The library reboots.
The library is now ready for operation. For more information on
Quantum PX720 remote management, see
chapter 3 on page 86.
Comentarios a estos manuales