Quantum PX720 Guía de usuario Pagina 93

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 259
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 92
Chapter 2 Basic Library Operations
OCP Components
Quantum PX720 User’s Guide 70
Figure 42 Change Network
Settings Screen
a To set the IP address, subnet mask, and gateway, use the up and
down arrows to select the appropriate number and press
Select
to accept.
b To enable/disable DHCP, use the up and down arrows to toggle
between enable/disable. Press
Select to accept the setting. If your
library is not connected to a network which uses a DHCP server
to assign IP information, disable this function.
4 To edit the setup information, use the up and down arrows to
highlight the section and press
Select.
To change the password, use the up and down arrows to select
Change Password and press
Select. To change the password,
enter a 6-digit password using the numbers provided on the
OCP. Press
Select to accept the new password. When prompted,
re-enter the password to confirm.
To restore the factory defaults, use the up and down arrows to
select Restore Factory Defaults and press
Select.
Note: For the network information such as the IP address to be
active, the library must reboot.
Back
Select
Vista de pagina 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 258 259

Comentarios a estos manuales

Sin comentarios