Quantum Scalar i40 Guía de usuario descargar pdf (Pagina 218)

Chapter 8: Installing, Removing, and Replacing Components

Installing the Library in a Desktop Kit

192 Quantum Scalar i40 and Scalar i80 User’s Guide

Space Requirements See the following:

• Physical Specifications on page 269 and

• Air Clearance Requirements on page 271

Procedure WARNING: Two people are required to safely lift the library.

1 If your library is currently installed in a rack, remove the magazines

and tape drives, and then remove the library from the rack. See

Removing the Library From a Rack on page 188.

2 Set the library on the desk or table in your chosen location.

3 Remove all the magazines from the library (if you have not already

done so), as follows:

a Insert the magazine lock override tool into the access hole in the

bottom of the magazine bezel (see

Figure 42).

b Use the tool to depress the release latch while gently pulling

outward on the magazine bezel handle. If the magazine is on

the right side, it will only slide out as far as the I/E station. To

release the magazine fully:

• On the Scalar i40 and the bottom right magazine of the

Scalar i80, reach under the open magazine and insert the

tool directly into the access hole in the library chassis to

depress the release latch, while pulling out on the magazine

bezel handle.

• On the top right magazine of the Scalar i80, reach under the

open magazine and press the release latch directly with

your finger, while pulling out on the magazine bezel handle.

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 327 328

Sin comentarios

Quantum Scalar i40 Guía de usuario Pagina 218