Quantum Scalar i40 Guía de usuario descargar pdf (Pagina 265)

Chapter 8: Installing, Removing, and Replacing Components

Packaging the Library for Moving or Shipping

Quantum Scalar i40 and Scalar i80 User’s Guide 239

WARNING: Two people are required to safely remove the

library from the rack.

• To remove the library from a desktop kit, remove the two top

cover screws. Loosen the captive thumbscrews on the library

chassis that are attached to the side panels of the desktop kit.

Slide the side panels one inch toward the rear of the library,

then pull the side panels off.

9 Make sure the robot is sitting on the floor of the library as follows:

Look inside the library through one of the magazine openings. If the

robot is not sitting on the floor of the library, reach inside and

gently press down on one of the robot’s metal side rods until the

robot starts moving. It should drift down to rest on the floor of the

library.

10 Reinstall the empty magazines in the library by pushing them in

until they stop.

11 If you removed the tape drives earlier, reinstall them in their proper

slots. Push them carefully into their slots and tighten the captive

thumbscrews.

12 Restrain the robot as follows (see Figure 61 on page 240):

a Turn the library carefully on its side (either the left or right side).

Make sure the front end of the library (the “rack ear”)

overhangs the edge of the table so that the library lies flat.

Caution: Do not turn the library upside down. Do not turn

the library more than 90 degrees from upright.

b Install four thumbscrews into the floor of the library in the

locations shown in

Figure 61 on page 240. They will screw

through the robot and hold it in place on the floor of the library.

1 2 ... 260 261 262 263 264 265 266 267 268 269 270 ... 327 328

Sin comentarios

Quantum Scalar i40 Guía de usuario Pagina 265