Quantum SDLT 320 Manual de usuario Pagina 120

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 150
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 119
APPENDIX A: Super DLTtape I Data Cartridge SDLT 220 and SDLT 320 Product Manual
A-6 March 2004 81-85002-01
5. Look closely at the screws that are visible on the bottom of the data cartridge.
As shown in Figure A-3 on page A-5, you should see five screws; if you see
only four screws, you have a very early data cartridge that is not completely
reliable. Transfer the data to a later-model cartridge, and discard the early-
model one.
6. Once again, look at the end of the data cartridge, holding it as shown in
Figure A-2.
7. Open the cartridge door by pressing on the tab in the door pivot notch. Take
care that you do not touch the tape leader.
8. Compare what you see inside the data cartridge door to Figure A-4 and
Figure A-5. Look for damage to the cartridge clips, including: 1) bent or toed-in
appearance on one or both clips, 2) improper seating (clips should be fully
retracted towards the left side of the opening), or 3) bending of the leader bar
that supports the clips.
Figure A-4. Problems to Look for Inside the Data Cartridge Door
Figure A-5. CAD Diagram Showing Limit of Buckling Clip Toe-in
Toed-in cartridge buckling clips (extreme)Tape leader is protruding out of the plastic shell
Buckling clip toe-in should not exceed this amount
Vista de pagina 119
1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 149 150

Comentarios a estos manuales

Sin comentarios