
CHAPTER 4: Installing Your Tape Drive SDLT 220 and SDLT 320 Product Manual
4-6 March 2004 81-85002-01
4.3 Configuring and Installing an Internal
Tape Drive
This section provides information for configuring and installing a tape drive into a
system. See “Configuring and Installing a Tabletop Drive” for information on
configuring and installing a tabletop tape drive.
Configuration for the SDLT system includes the following:
• Setting the SCSI ID for the drive (default = SCSI ID 5).
• Configuring the drive to provide TERMPWR.
• Setting the configuration jumper (default = wide SCSI enabled).
If you want to change any of the settings, refer to the applicable subsection;
otherwise proceed directly to the tape drive’s installation procedures in “Installing
the Internal Tape Drive” on page 4-11.
CAUTION: Before you begin, review the safety, ESD, and handling
precautions described at the beginning of this chapter to
avoid personal injury or damage to equipment.
Comentarios a estos manuales