Quantum EC-LLDAA-YF-B Guía de usuario descargar pdf (Pagina 56)

Chapter 3 Operating the Autoloader

Using Magazines and Magazine Blanks

36 Quantum SuperLoader 3 User’s Guide

Note: It is recommended that you fully remove the magazine to load

and unload cartridges. If the magazine is not fully removed, do

not rotate the magazine.

To Identify a Slot:

Each slot has an identification number that is exposed when the slots

are in the upper section of the magazine. With the magazine removed

from the autoloader, you can see the identification mark on the top side

of the magazine through one of two windows on the upper surface of

the magazine.

Each magazine carrier is labeled 1/9, 2/10, 3/11, and so forth. Lower

numbers 1 - 8 reference slots in the left magazine. Higher numbers 9 -

16 reference slots on the right magazine if the optional right magazine

is installed.

To Load Cartridges into a Fully Ejected Magazine:

1 To load cartridges into the magazine, center a slot within one of the

openings located on the side of the magazine.

2 Properly orient the cartridge.

Note: There is a keying feature in each slot that only allows you to

fully insert the cartridge one way.

3 Fully insert the cartridge into the slot.

When pushing the cartridge into the slot, you will feel a small

resistance (detente) until the cartridge is properly latched into the

slot. All forward progress stops when the cartridge is fully inserted.

You can remove a cartridge in the same manner as you insert it. Use the

knobs to center the desired slot(s) in the openings on the side of the

magazine. Using your thumb and index finger, pull out the cartridge.

You will feel a small resistance, but continue to pull the cartridge until it

comes free.

To Unload Cartridges from a Fully Ejected Magazine:

1 Pull the ejected magazine until the large upper slot is accessible.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 209 210

Sin comentarios

Quantum EC-LLDAA-YF-B Guía de usuario Pagina 56