Quantum Scalar 50 LTO-3HH Guía de usuario descargar pdf (Pagina 44)

Chapter 1 Library Description

Getting Started

Quantum Scalar 50 User’s Guide 20

1 The Scalar 50 tape drives and system controller board are accessed

from the back of the library (refer to

Connecting to Host

Workstations on page 31).

2 Connect Ethe

rnet port located on the back of the library on the

system controller board to the local area network (see figure

9).

Figure 9 Connecting the

Library to the Local Area

Network

Ethernet port System controller boardInternal communication

with TC2201 CPCI card

Loading Tape Cartridges 1

Before operating the library, load the appropriate tape cartridges (LTO or

SDLT) into the library starting with the left-hand magazine (see figure

and figure

3 for slot locations).

Initial Configuration 1

The Quantum Scalar 50 must be initially configured with an IP address

before the remote management software is available. Refer to

Using the

OCP on page 37 for information on configuring your Scalar 50 network

information and preparing for operation.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 289 290

Sin comentarios

Quantum Scalar 50 LTO-3HH Guía de usuario Pagina 44