Quantum DLT VS160 Manual de usuario descargar pdf (Pagina 54)

ValueLoader Administration

Configuring the ValueLoader

40 Quantum ATL ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual

• ValueLoader Operating Modes

•Updating firmware

To access the Configuration menu from the Home screen or main

menu, press the

[+] or [–] button until “Configuration” appears on

the top line of the LCD screen. Press the

[Enter] button and then [+]

[–] to access the available options. Press the [Enter] button to

execute the displayed menu option.

Resetting the

ValueLoader

This option resets the ValueLoader robotics and the tape drive

within the ValueLoader, forces a new cartridge inventory, and

clears any current error condition.

To access this option, follow these steps:

1 From the Home screen or main menu, press the [+] or [–] button

until “Configuration” appears on the top line of the LCD

screen.

2 Press [Enter] to select.

3 Press the [+] or [–] button until “Reset” appears on the LCD

screen.

4 Press the [Enter] button to reset the ValueLoader.

After initialization, the ValueLoader returns to normal operation

and displays the Home screen.

Changing the SCSI

This option changes the SCSI ID the ValueLoader uses. The

ValueLoader operates as a single SCSI device with two separate

SCSI Logical Unit Numbers (LUNs): one LUN (0) is for the tape

drive, the other (1) is for the ValueLoader robotics.

The default SCSI ID is 5. You should only need to change the SCSI

ID if there are other devices on the SCSI bus with the same SCSI

ID.

Note: This option is primarily used if the ValueLoader is in an

error state.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 89 90

Sin comentarios

Quantum DLT VS160 Manual de usuario Pagina 54