Quantum DLT VS160 Manual de usuario descargar pdf (Pagina 57)

ValueLoader Administration

Configuring the ValueLoader

Quantum ATL ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual 43

loaded into the ValueLoader’s tape drive while in Sequential

Mode, you may set Circular and Autoload options from the

ValueLoader front panel.

Circular Mode On/Off. This option turns Circular Mode on or off,

and is used only when in sequential mode. When Circular Mode is

on, after the ValueLoader has cycled through all available

cartridges, it then reloads the original first cartridge in the

sequence. If Circular Mode is turned off and the last cartridge has

been unloaded, the ValueLoader stops loading cartridges until you

manually load another cartridge.

To access this option, follow these steps:

1 From the Home screen or main menu, press the [+] or [–] button

until “Configuration” appears on the top line of the LCD

screen.

2 Press the [Enter] button to select.

3 Press the [+] or [–] button until “Circular Mode” appears on the

LCD screen. The second line on the LCD screen indicates the

current status, either “On” or “Off.”

4 Press the [Enter] button. The LCD screen indicates whether you

are about to turn Circular Mode on or off.

5 Press the [Enter] button to accept the change to Circular Mode

[Cancel] to exit and not save the changes.

Autoload Mode On/Off. This option turns Autoload mode on or off,

and is only used when in sequential mode. When Autoload mode

is on, the ValueLoader automatically loads the cartridge from the

lowest numbered full slot into the tape drive when powered on. It

then follows standard sequential operation as described in

Sequential Mode

on page 42.

Caution: Use caution when choosing Circular Mode as it

makes it possible to overwrite data on previously

written cartridges.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 89 90

Sin comentarios

Quantum DLT VS160 Manual de usuario Pagina 57