
Chapter 8 Logs and Troubleshooting
Tape Drive Logs
Quantum SuperLoader 3 User’s Guide 115
Context Information
Context Information followed by the 12 double-words are for
engineering use only and cannot be interpreted without firmware
source code.
Ta p e Dr i v e L o g s
• The tape drive generates six types of logs (see “Tape Drive Error
Logs” on page 143). For troubleshooting errors, you will only use
SCSI Check Condition Error logs, Bugcheck Error logs, and Event
Error logs.:
• “
SCSI Check Condition Error Logs” on page 144
D5–DE Cartridge flags located on
the magazine may be bad or
the sensor to detect the flags
may have a problem.
•Check the
Task ID in the Hard Error log to determine
if the problem is the right or the left magazine.
• Remove and reinsert the magazine.
• Try a different magazine, if possible.
• Make sure that the sensor is not blocked by debris.
• Power cycle the autoloader.
• If all previous steps fail, contact customer support
DF Jammed Cartridge • Check the
Task ID in the Hard Error log to determine
if the problem is the right or the left magazine.
• Power cycle the autoloader.
• Disconnect all data cables from the autoloader.
• Power cycle the autoloader.
• Use the following OCP commands:
Commands
Eject
Tape - Mailslot
From Drive
• If all previous steps fail, contact customer support
Error Type Description Suggested Actions
Comentarios a estos manuales