Quantum EC-LLDAA-YF-B Guía de usuario descargar pdf (Pagina 54)

Chapter 3 Operating the Autoloader

Using Magazines and Magazine Blanks

34 Quantum SuperLoader 3 User’s Guide

Magazine Load/Unload

Command

• When issuing a Load/Unload command to the autoloader, the

system automatically ejects the right-hand magazine. To remove the

left-hand magazine using the Load/Unload command, you must:

1 Remove the right magazine.

2 Replace the right magazine with a magazine blank.

3 Issue the Load/Unload command again. The system will then eject

the left magazine.

4 If you want to have the magazine in the right-hand bay, replace the

magazine blank in the right-hand bay with a cartridge magazine.

Installing a Magazine To install a magazine into the autoloader:

1 Grasp the magazine by the handle with one hand and support it

underneath with the other hand.

2 Slide the magazine into the magazine bay until it clicks.

Make sure that you position the magazine correctly. It should slide

into the magazine bay smoothly. If you meet resistance, verify the

orientation of the magazine.

The magazine is correctly installed when you feel it click into place

and the front is flush with the front panel.

Left Mag Inserted or Right

Mag Inserted

displays on the LCD. The autoloader automatically

proceeds to run an inventory.

Caution: Be careful not to turn the knob on the side of the magazine

while the magazine is partially inserted into the autoloader.

Doing so may cause damage to the magazine or the

autoloader.

Manually Operating the

Magazine

The following section describes how to operate a magazine.

There are two knobs located on each end of the magazine. You can

move the slots within the magazine by turning these two knobs and

aligning a slot with one of the two openings.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 209 210

Sin comentarios

Quantum EC-LLDAA-YF-B Guía de usuario Pagina 54