Quantum 1200 Series DAT Autochanger Guía de usuario Pagina 183
- Pagina / 294
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
SDLT 600 SCSI Interface Guide Chapter 4: SCSI Commands
81-81200-02 REV A01 January 2005 4-141
3h Exclusive
Access
READS: Exclusive; any command from any initiator other than the
initiator holding the persistent reservation that attempts a transfer from
the drive results in a reservation conflict.
WRITES: Exclusive; any command from any initiator other than the
initiator holding the persistent reservation that attempts a transfer to the
drive results in a reservation conflict.
ADDITIONAL RESERVATIONS: Restricted; any PERSISTENT
RESERVE OUT command with the Reserve service action from any
initiator other than the initiator holding the persistent reservation
results in a reservation conflict. The initiator that holds the persistent
reservation can reserve the logical unit, extents, or elements as long as
the persistent reservations do not conflict with any reservations already
known to the drive.
4h Obsolete ---
5h WRITE
Exclusive
Registrants
Only
READS: Shared; any application client on any initiator may execute
commands that perform transfers from the drive to the host.
WRITES: Exclusive; any command from an initiator that has not
previously performed a Register service action with the drive that
attempts a transfer to the drive results in a reservation conflict.
ADDITIONAL RESERVATIONS: Allowed; any initiator may reserve
the logical unit, extents, or elements as long as the persistent
reservations to not conflict with any reservations already known to the
drive.
6h Exclusive
Access
Registrants
Only
READS: Exclusive; any command from an initiator that has not
previously performed a Register service action with the drive that
attempts a transfer from the drive results in a reservation conflict.
WRITES: Exclusive; any command from an initiator that has not
previously performed a Register service action with the drive that
attempts a transfer to the drive results in a reservation conflict.
ADDITIONAL RESERVATIONS: Allowed; any initiator may reserve
the logical unit, extents, or elements as long as the persistent
reservations to not conflict with any reservations already known to the
drive.
7h -
Fh
Reserved Not applicable.
Table 4-81. PERSISTENT RESERVATION IN Type Codes (Continued)
Code Name Description
- 6'/7 1
- Table of Contents 3
- List of Tables 9
- List of Figures 15
- Introduction 21
- 1.3 Related Documents 22
- 1.4 Structure of this Manual 22
- 1.5 Conventions 23
- 1.6 For More Information 23
- 1.7 Reader Comments 24
- SCSI Parallel Protocol 25
- 2.3.1 Attention Condition 26
- RESET or DISCONNECT message 27
- 2.3.2 Reset Condition 28
- SCSI Messages 29
- 3.2 Supported SCSI Messages 31
- 3.2.1 ABORT TASK SET (06h) 32
- 3.2.2 TARGET RESET (0Ch) 33
- 3.2.3 TASK COMPLETE (00h) 33
- 3.2.4 DISCONNECT (04h) 33
- 3.2.5 IDENTIFY (80h - FFh) 34
- 3.2.10 MESSAGE REJECT (07h) 37
- 3.2.11 NO OPERATION (08h) 37
- WRITE BUFFER 3Bh Page 4-249 45
- 4.1.4 Behavior at Power-On 49
- 4.2 SCSI Command Descriptions 50
- 4.3 ERASE Command (19h) 52
- 4.4 INQUIRY Command (12h) 53
- Unit Serial Number Page (80h) 62
- • Logical Unit NAA Identifier 63
- Logical Unit NAA Identifier 66
- 4.5 LOAD UNLOAD Command (1Bh) 70
- 4.6 LOCATE Command (2Bh) 72
- 4.7 LOG SELECT Command (4Ch) 73
- 4.8 LOG SENSE Command (4Dh) 81
- Log Page” on page 4-43 90
- 0000h – 000Fh) 104
- — Field Descriptions 108
- SDLT 600 109
- SCSI Interface Guide 109
- SCSI Commands 109
- 81-81200-02 109
- 4.9.1 Mode Parameter List 111
- Mode Parameter Header 113
- SDLT tape drive 116
- Mode Page Descriptor 117
- 4.9.10 TapeAlert Page (1Ch) 134
- 4.10.3 MODE SENSE Mode Pages 155
- Control Mode Page (0Ah) 160
- Data Compression Page (0Fh) 162
- Medium Partition Page (11h) 167
- Port Control Page (19h) 169
- Parameter List 176
- Command (1Eh) 194
- 4.14 READ Command (08h) 195
- ATTRIBUTE LIST Service Action 202
- VOLUME LIST Service Action 203
- PARTITION LIST Service Action 204
- Attributes 205
- Attribute Identifier Values 207
- AND DEVICE 209
- Field Descriptions 212
- Standard Host Type Attributes 219
- Value Meaning 220
- 00h No code specified (ASCII) 220
- 01h - FFh Reserved 220
- 3C 03 A2 00 00 00 00 00 04 80 228
- 4.17.3 Data Mode (02h) 229
- 4.17.4 Descriptor Mode (03h) 229
- Command (A3h) 250
- Descriptions 251
- FUNCTIONS Command (A3h) 256
- 4.30 REWIND Command (01h) 274
- 2. Rewinds the tape 276
- 4. Rewinds the tape 276
- RESULTS command 277
- 4.33 SPACE Command (11h) 281
- 4.35 VERIFY Command (13h) 284
- 4.36 WRITE Command (0Ah) 285
- Exception Conditions 286
- 4.38.2 Write Data Mode (02h) 292
Relacionado con productos y manuales para Software Quantum 1200 Series DAT Autochanger
Software Quantum SuperLoader 3 Guía de usuario
(160 paginas)
(160 paginas)
Software Quantum SuperLoader Guía de usuario
(196 paginas)
(196 paginas)
Software Quantum Scalar i2000 Guía de usuario
(544 paginas)
(544 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.120 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales