Quantum 1200 Series DAT Autochanger Guía de usuario descargar pdf (Pagina 22)

Related Documents SDLT 600 SCSI Interface Guide

1-2 January 2005 81-81200-02 REV A01

1.3 Related Documents

• SDLT 600 Fibre Channel Interface Guide (81-81202-02)

• SDLT 600 Product Manual (81-81184-01)

• Current standards documents available from www.t10.org:

 SCSI Architecture Model (SAM-2)

 SCSI Parallel Interface (SPI-3)

 SCSI Primary Commands (SPC-2)

 SCSI Stream Commands (SSC)

1.4 Structure of this Manual

• Chapter 1, Introduction, is the chapter you are currently reading.

• Chapter 2, SCSI Parallel Protocol, provides an overview of SDLT tape drive-specific SCSI

information. Background knowledge of the SCSI-3, SAM, SPC, SPI, and SSC standards is

assumed.

• Chapter 3, SCSI Messages, lists and describes the SCSI messages supported by SDLT tape

drives. The SCSI message system allows communication between SCSI initiators and SCSI targets

(the SDLT tape drive, in this case) for interface management and command elaboration and

qualification.

• Chapter 4, SCSI Commands, describes in detail each command supported by SDLT tape drives.

The SCSI command system enables a SCSI initiator to direct an SDLT tape drive to perform a

wide range of operational and diagnostic functions. This chapter also provides Sense Key and

Additional Sense Code information for the REQUEST SENSE and SEND DIAGNOSTIC SCSI

commands as well as density codes for the MODE SELECT and MODE SENSE commands.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 293 294

Sin comentarios

Quantum 1200 Series DAT Autochanger Guía de usuario Pagina 22