
Chapter 5 Running Diagnostic Programs
Running the Move Location Test
ATL M-Series User’s Guide 85
test cycles. The home location depends on whether the destination is a
tape drive or a magazine slot:
• If the destination is a tape drive, the home location is slot 1 of the
level 1 left magazine.
• If the destination is a magazine slot, the home location is the first
installed tape drive.
To run the
Move Location test:
1 Access the
Diagnostics Menu screen (see Accessing the Diagnostics
Menu Screen on page 77).
2 Press the
Up and Down buttons to select General.
3 Press
Select.
The GUI displays the
Diags: General screen (see figure 48 on page 79).
4 Press the
Up or Down buttons to select Move Location.
5 Press
Select.
The GUI displays the
Diag: Move-Location screen (see figure 54).
Figure 54 Sample
Diag: Move-Location
Screen
6 Press the Up and Down buttons to select the destination for the robotic
hand.
7 Press
Select.
Comentarios a estos manuales