
Chapter 3 Changing the Library Configuration
Changing the Off-Line Time Setting
60 ATL M-Series User’s Guide
5 Press Select.
To return to the
Configuration screen without changing the option
setting, press
Cancel.
6 Press
Main to return to the main screen.
Changing the Off-Line Time Setting 3
When you access the Menu screen using the GUI, the library becomes
NOT READY and will not respond to any SCSI commands issued. If you
leave the library unattended in menu mode, the library goes back to a
READY state after a pre-set time-out, controlled by the
Off-Line Time
option. You can set this time-out to any value from 1 to 99 minutes, or
turn it off.
To set the
Off-Line Time:
1 Access the
Configuration screen (see Accessing the Configuration
Screen on page 49).
2 Press the
Up or Down buttons until Off-Line Time is highlighted.
3 Press
Select.
4 Use the
Up or Down buttons to select the desired Off-Line Time setting.
The available settings are
1 through 99 and Disabled.
5 Press
Select.
To return to the
Configuration screen without changing the option
setting, press
Cancel.
6 Press
Main to return to the main screen.
Note: The default setting is
Disabled.
Comentarios a estos manuales