
Chapter 5 Running Diagnostic Programs
Running the Display Test
ATL M-Series User’s Guide 87
13 Press Back.
The GUI displays the cycle count screen.
14 Press
Cancel, then Back to return to the Diags: General screen.
Running the Display Test 5
The Display Test allows you to verify that the GUI has no missing pixels
and that the two status indicators on the library front panel work
correctly.
To run the
Display Test:
1 Access the Diagnostics Menu screen (see Accessing the Diagnostics
Menu Screen on page 77).
2 Press the
Up and Down buttons to select General.
3 Press
Select.
The GUI displays the
Diags: General screen (see figure 48 on page 79).
4 Press the
Up and Down buttons to select Display Test.
5 Press
Select.
The test starts. The GUI goes dark momentarily, and both of the
status indicators flash. This test lasts approximately three seconds.
Comentarios a estos manuales