Quantum TC-L53FN-AR Guía de usuario Pagina 26

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 96
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 25
Chapter 2 Installation Procedures
Installing the Internal LTO-5 Tape Drive
12 LTO-5 Tape Drive User’s Guide
Restarting the Internal Half-Height Tape Drive System
After connecting the internal drive interface and DC power cables:
1 Restart the workstation or server system.
2 Verify that the internal LTO-5 Half-Height Tape Drive comes on and
completes the Power On Self Test (POST) functions.
As required, proceed to Installing the LTO Driver Software
on page 19.
Installing the Internal
LTO-5 Full-Height Tape
Drive
To install the internal LTO-5 Full-Height Tape Drive, complete the
following procedures in the order presented:
1 Mounting the Internal Full-Height Tape Drive
on page 12
2 Connecting the Internal Full-Height Drive Interfaces
on page 13
3 Restarting the Internal Full-Height Tape Drive System
on page 15
4 Installing the LTO Driver Software
on page 19, if required
Mounting the Internal Full-Height Tape Drive
Mount the internal drive in a 5.25-inch, full-height drive bay as follows:
1 As required:
a Save and close your open files and terminate all running
applications.
b Shut down the workstation or server system.
c Disconnect the system AC power cord from the facility AC
power receptacle.
2 Remove the cover from the workstation or server system.
Note: See your computer manufacturer’s instructions for the proper
procedures to remove the cover.
3 Select an available 5.25-inch full-height bay and, if required, remove
the bay cover.
4 Position the drive in the bay and align mounting holes with the
holes in the chassis (see figure 6
).
5 Secure the drive using two screws on each side of the tape drive.
Vista de pagina 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 95 96

Comentarios a estos manuales

Sin comentarios