Quantum TC-L53FN-AR Guía de usuario descargar pdf (Pagina 49)

Chapter 3 Operation

Cleaning the Tape Drive

LTO-5 Tape Drive User’s Guide 35

• Experience excessive errors while reading or writing

•The Clean LED is flashing

This means that the drive needs to be cleaned.

The LTO cleaning cartridge has the same dimensions as the tape

cartridge and contains an LTO Cartridge Memory (LTO-CM), but is

loaded with cleaning media instead of recording media. Always keep

the LTO cleaning cartridge in its protective case when not in use.

Procedure

To clean the LTO-5 Tape Drive:

1 Load an Ultrium Universal Cleaning cartridge into the tape drive.

2 The drive will carry out its cleaning cycle and eject the cartridge on

completion (which can take up to 5 minutes). During the cleaning

cycle the orange Clean LED will be on solidly and the green Ready

LED will flash.

Each Ultrium universal cleaning cartridge can be used up to 50

times with Ultrium tape drives. If the cleaning cartridge is ejected

immediately with the Tape LED on, it has expired.

Note: If the LTO-5 Tape Drive does not recognize the cartridge as an

LTO cleaning cartridge, the drive stops the cleaning process and

ejects the cartridge.

3 After the cleaning process completes, depending on the drive

configuration, either:

a The drive automatically ejects the Ultrium Universal Cleaning

cartridge, or

b You must press the Eject button to eject the Ultrium Universal

Cleaning cartridge.

4 Write the date on the Ultrium Universal Cleaning label for future

reference.

Always discard used-up Ultrium Universal Cleaning cartridges.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 95 96

Sin comentarios

Quantum TC-L53FN-AR Guía de usuario Pagina 49