Quantum TC-L53FN-AR Guía de usuario descargar pdf (Pagina 28)

Chapter 2 Installation Procedures

Installing the Internal LTO-5 Tape Drive

14 LTO-5 Tape Drive User’s Guide

Figure 7 Internal Full-Height

Drive Interfaces

Connect the interface cables to the internal drive as follows:

1 Verify that the system is shut down and the AC power cord is

disconnected from the facility AC power receptacle.

2 Connect the SAS connector on the back of the tape drive to a serial

SCSI host bus adapter (HBA) installed in the server.

3 Ensure that a 4-pin Molex power connector is plugged into the

power inputs of the SAS cable as shown in figure 7

4 Reinstall the system cover.

5 Reconnect the system AC power cord to the facility AC power

receptacle.

After connecting the internal drive interfaces, proceed to Restarting the

Internal Full-Height Tape Drive System in the following subsection.

29-pin SFF-8482 SAS cable connector

4-pin Molex power

connector

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 95 96

Sin comentarios

Quantum TC-L53FN-AR Guía de usuario Pagina 28