Quantum TC-L53FN-AR Guía de usuario descargar pdf (Pagina 33)

Chapter 2 Installation Procedures

Installing the LTO Driver Software

LTO-5 Tape Drive User’s Guide 19

3 Verify that the tabletop LTO-5 Full-Height Tape Drive AC power

switch is set to the off position, and connect the AC power cord to

the power connector on the back of the drive.

4 Connect the drive AC power cord to the facility AC power

receptacle.

5 Reconnect the workstation or server system AC power cord to the

facility AC power receptacle.

After connecting the tabletop drive interface and AC power cables,

proceed to Restarting the Tabletop Full-Height Tape Drive System

in the

following subsection.

Restarting the Tabletop Full-Height Tape Drive System

After connecting the tabletop drive interface and AC power cables:

1 Set the tabletop drive AC power switch to the on position.

2 Restart the workstation or server system.

3 Verify that the tabletop LTO-5 Half-Height Tape Drive comes on and

completes the Power On Self Test (POST) functions.

As required, proceed to Installing the LTO Driver Software

Installing the LTO Driver Software

If you intend to use the LTO-5 Tape Drive with the Microsoft® native

backup applet on a Windows 2000, Windows Server® 2003, Windows

2008 Server®, Windows XP®, or Windows Vista operating system,

install the appropriate version of the LTO driver software available at

www.quantum.com

Note: The LTO driver software is not necessary with commercial

backup application software.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 95 96

Sin comentarios

Quantum TC-L53FN-AR Guía de usuario Pagina 33