Quantum TC-L32BX-EY Guía de usuario descargar pdf (Pagina 23)

Chapter 2 Installation Procedures

Installing the Internal LTO-3 Half-Height Tape Drive

LTO-3 Half-Height Tape Drive User’s Guide 9

Installing the Internal LTO-3 Half-Height Tape Drive

To install the internal LTO-3 Half-Height Tape Drive, complete the

following procedures in the order presented:

1 Depending on the interface configuration of the drive:

2 C

onnecting the Internal Drive Interface and DC Power Cables on

page 15.

3 Restarting the Internal

Tape Drive System on page 17

4 Installing the LTO Driver Software

on page 25, if required.

5 Registering the LTO-3 Half-Height Tape Drive

on page 25.

IF the drive interface is . . . THEN . . .

parallel Small Computer

System Interface (SCSI),

proceed to Configuring the Internal

Parallel SCSI Tape Drive in the

following subsection to configure

the parallel SCSI ID and bus

terminator power.

serial-attached SCSI (SAS), there is no need to configure the

SCSI ID or bus termination, as SAS

is a point-to-point architecture. Skip

to Mounting the Internal Tape

Drive on page 13

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 108 109

Sin comentarios

Quantum TC-L32BX-EY Guía de usuario Pagina 23