Quantum TC-L32BX-EY Guía de usuario descargar pdf (Pagina 37)

Chapter 2 Installation Procedures

Installing the Tabletop LTO-3 Half-Height Tape Drive

LTO-3 Half-Height Tape Drive User’s Guide 23

See figure 11 for tabletop parallel SCSI bus termination

examples.

b For the SAS tabletop drive, attach the external SAS interface cable

to the 26-pin SFF-8088 mini-SAS connector on the back of the

drive.

3 Verify that the tabletop LTO-3 Half-Height Tape Drive AC power

switch is set to the off position, and connect the AC power cord to the

power connector on the back of the drive.

4 Connect the drive AC power cord to the facility AC power receptacle.

5 Reconnect the workstation or server system AC power cord to the

facility AC power receptacle.

After connecting the tabletop drive interface and AC power cables,

proceed to Restarting the Tabletop Drive System

in the following

subsection.

Caution: The LTO-3 Half-Height Tape Drive with the

parallel SCSI interface is a low voltage differential

(LVD) SCSI device. Install it only in LVD

environments. Plugging an LVD drive into a high

voltage differential (HVD) bus makes the entire

bus nonfunctional and may permanently damage

the drive or other SCSI devices on the bus.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 108 109

Sin comentarios

Quantum TC-L32BX-EY Guía de usuario Pagina 37