Quantum TC-L32BX-EY Guía de usuario descargar pdf (Pagina 26)

Chapter 2 Installation Procedures

Installing the Internal LTO-3 Half-Height Tape Drive

LTO-3 Half-Height Tape Drive User’s Guide 12

Configuring the Internal Parallel SCSI Terminator Power 2

By default, terminator power is enabled on the internal parallel SCSI

LTO-3 Half-Height Tape Drive. If you use this default setting, then the

last device at the end of the parallel SCSI bus must have either:

• A parallel SCSI bus terminator

• Terminator power enabled

See figure 3

for examples of internal parallel SCSI bus termination.

To disable terminator power, remove the jumper across pins 11 and 12

(see figure 2

10 Open Shunted Open Shunted

11 Shunted Shunted Open Shunted

12 Open Open Shunted Shunted

13 Shunted Open Shunted Shunted

14 Open Shunted Shunted Shunted

15 Shunted Shunted Shunted Shunted

Note: The internal parallel SCSI LTO-3 Half-Height Tape Drive does

not provide SCSI termination. The last device at the end of the

parallel SCSI bus chain must have a SCSI bus terminator.

Jumper Pins

SCSI ID 1–23–45–67–8

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 108 109

Sin comentarios

Quantum TC-L32BX-EY Guía de usuario Pagina 26