Quantum TC-L32BX-EY Guía de usuario descargar pdf (Pagina 36)

Chapter 2 Installation Procedures

Installing the Tabletop LTO-3 Half-Height Tape Drive

LTO-3 Half-Height Tape Drive User’s Guide 22

Figure 10 Tabletop SAS

Interface and Power Cable

Connectors

Connect the interface and AC power cables to the tabletop drive as

follows:

1 As required:

a Save and close your open files and terminate all running

applications.

b Shut down the workstation or server system.

c Disconnect the system AC power cord from the facility AC

power receptacle.

2 Depending on the interface configuration of your tabletop drive:

a For the parallel SCSI tabletop drive:

• Attach the SCSI IN interface cable to one of the 68-pin

parallel SCSI interface connectors on the back of the drive.

• Attach either the SCSI OUT interface cable or a SCSI

terminator to the other parallel SCSI interface connector on

the back of the drive.

If the tabletop LTO-3 Half-Height Tape Drive is the last or

only device in a SCSI chain, you must install a 68-pin low

voltage differential (LVD) terminating plug on the unused

parallel SCSI connector.

26-pin SFF-8088 mini-SAS connector

AC power switch

AC power connector

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 108 109

Sin comentarios

Quantum TC-L32BX-EY Guía de usuario Pagina 36